FRONT REGULATOR

Removal and Installation

REMOVAL

1. Remove the front door finisher. For Sedan Refer to See: Front Door Panel\Service and Repair\Removal and Installation\Sedan. For Coupe Refer to See: Front Door Panel\Service and Repair\Removal and Installation\Coupe
2. Remove the bolt hole covers.
3. Remove the upper door module assembly bolts and the upper window regulator bolts.

4. Reconnect the power window switch to raise/lower the door glass until the door glass bolts (A) can be seen.
5. Remove the door glass bolts.

6. Raise the door glass and hold with a suction lifter (A).
7. Disconnect the window motor connector (A).

8. Remove the door module assembly.

Inspection AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.

• Excessive cable wear.

• Regulator channel deformation (A).
• Apply grease for each sliding part. Apply grease at the application points (A) as shown.