Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Windows and Glass » Rear Door Window Glass » Service and Repair » Removal and Replacement » Removal And Installation  
 
 
  Removal And Installation  
 

REAR DOOR GLASS

Removal and Installation

REMOVAL

  1. Remove the rear door finisher. Refer to See: Body and Frame\Doors, Hood and Trunk\Front Door Panel\Service and Repair\Removal and Installation\Sedan.
  2. Remove the plastic vapor barrier, being careful not to tear/damage it.
  3. Temporarily reconnect the power window switch to the door harness.
  4. Operate the power window switch to raise/lower the door glass until the door glass bolts (A) can be seen.

  

  1. Remove the door glass bolts (A).
  2. Remove the door glass.

  

  1. Remove the partition sash from the glass run.
    • Remove the partition sash bolt (lower) (B) and screw (upper) (A) to remove the sash.

  

  1. Remove the partition glass from the inside of the door in the direction as shown.

INSTALLATION
Installation is in the reverse order of removal. Reset Limit Switch after Installation: See: Windows\Testing and Inspection\Programming and Relearning\Setting of Limit Switch

  • After installation inspect and adjust as necessary.