Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Windows and Glass » Rear Door Window Regulator » Service and Repair » Removal and Replacement » Removal And Installation  
 
 
  Removal And Installation  
 

REAR REGULATOR

Removal and Installation

REMOVAL

  1. Remove the rear door finisher. Refer to See: Body and Frame\Doors, Hood and Trunk\Front Door Panel\Service and Repair\Removal and Installation\Sedan.
  2. Remove the plastic vapor barrier, being careful not to tear/damage it.
  3. Temporarily reconnect the power window switch to the door harness.

  

  1. Operate the power window switch to raise/lower the door window until the glass mounting bolts (A) can be seen.
  2. Remove the door glass bolts (A).

  

  1. Raise up the door glass and hold with a suction lifter (A).
  2. Disconnect the window motor connector.

  

  1. Remove the window regulator bolts (A) and remove the window regulator from the rear door panel.

INSTALLATION
Installation is in the reverse order of removal. Reset Limit Switch after Installation: See: Windows\Testing and Inspection\Programming and Relearning\Setting of Limit Switch

  • After installation, inspect and adjust as necessary.