Remove wheel hub and bearing assembly from drive shaft using a puller or suitable tool.
CAUTION:
When removing wheel hub and bearing assembly, do not apply an excessive angle to drive shaft joint. Also be careful not to excessively extend slide joint.
Support drive shaft when removing.
Remove wheel hub and bearing assembly bolts using power tool.
Remove splash guard and wheel hub and bearing assembly from steering knuckle.
Inspection AFTER REMOVAL
Check for deformity, cracks and damage on each part, replace if necessary.
Ball Joint Inspection
Check for boot breakage, axial looseness, and torque of transverse link ball joint and repair as necessary.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Do not reuse non-reusable parts.
When installing wheel hub and bearing assembly to steering knuckle, align cutout in toner ring cover with wheel sensor mounting hole in steering knuckle.