Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » P Code Charts » P1715  
 
 
  P1715  
 

P1715 INPUT SPEED SENSOR (PRIMARY SPEED SENSOR)

Description
ECM receives primary speed sensor signal from TCM via the CAN communication line. ECM uses this signal for engine control.

DTC Logic

DTC DETECTION LOGIC

NOTE:

  • If DTC P1715 is displayed with DTC UXXXX first perform the trouble diagnosis for DTC UXXXX. Refer to See: U Code Charts\U0101.
  • If DTC P1715 is displayed with DTC P0335, first perform the trouble diagnosis for DTC P0335. Refer to See: P0335.
  • If DTC P1715 is displayed with DTC P0340, P0345, first perform the trouble diagnosis for DTC P0340, P0345. Refer to See: P0340.
  • If DTC P1715 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. Refer to See: P0605.
  • If DTC P1715 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to See: P0607.

  

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds. >> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine.
  2. Drive vehicle at a speed of more than 50 km/h (31 MPH) for at least 5 seconds.
  3. Check 1st trip DTC. Is 1st trip DTC detected?

YES >> Go to Diagnosis Procedure.
NO >> Inspection END

Diagnosis Procedure
1.CHECK DTC WITH TCM
Check DTC with TCM. Refer to See: Testing and Inspection.
Is the Inspection result normal?
YES >> GO TO 2.
NO >> Perform trouble shooting relevant to DTC indicated.
2.REPLACE TCM
Replace TCM. Refer to See: Powertrain Management\Transmission Control Systems\Control Module, CVT\Service and Repair\CVT RE0F09B\Removal And Installation.
>> Inspection END